obddata

Displays the current OBD engine parameters and corresponding values obtained from the OBDII transmitter and the time since they were last updated.

Notes:

• If no engine parameters have been obtained yet, the command returns ERROR
• This command is read-only.
  

*FW 5172 and above:

• If you see any of the following outputs:

  ***CAN error limit reached, CAN not enabled for this session***
  OR
  ***CAN error detected, CAN disabled for this session***
  

  ...that means the CTM200 has detected a CAN error and will stop communicating to the vehicle ECU. You can configure the CTM200 to be more/less sensitive to CAN disabling with the cmd can errmax command
• If a CAN cable is NOT connected between the CTM200 and a vehicle ECU, the CTM200 will interpret this as a CAN error.

Examples:

1. display OBD/J1939 engine parameters and time since they were last updated :
   cmd obddata

See Also: OBD2/J1939 Parameters Table, Engine Diagnostics Support

Firmware revision 1.2.0_RC5 (1153)